No hand or thumb warmer

No hand or thumb warmer

Post by Msk5 » Tue, 17 Dec 1996 04:00:00


Would a faulty voltage regulator cause this? Everything else works. I
ohm'd out the switch, and each heating element and that seemed to be
alright. I tried to get a voltage reading right off the regulator but
didn't get anything. The engine was at idle, should I have gotten a
reading?

Mike

 
 
 

No hand or thumb warmer

Post by reg.thompso » Tue, 17 Dec 1996 04:00:00

Quote:

> Would a faulty voltage regulator cause this? Everything else works. I
> ohm'd out the switch, and each heating element and that seemed to be
> alright. I tried to get a voltage reading right off the regulator but
> didn't get anything. The engine was at idle, should I have gotten a
> reading?

> Mike

Mike, what voltmeter range were you using? -> it should be AC voltage.
Also, the lighting coil runs all accessories, lights, gauges,
handwarmers, if these work the coil & regulator is fine.  What sled do
you have.

96 MXZ670
97 MXZ583